hi all,
i had a topseed remote control (1784:0008) working fine about 3 months ago. i reinstalled 13.37 and cannot get it to work again. the receiver gets registered fine:
Code:
[ 627.426023] usb 5-1: new full speed USB device using uhci_hcd and address 3
[ 627.625060] usb 5-1: config 1 interface 0 altsetting 0 endpoint 0x1 has an invalid bInterval 0, changing to 32
[ 627.625066] usb 5-1: config 1 interface 0 altsetting 0 endpoint 0x82 has an invalid bInterval 0, changing to 32
[ 627.659048] usb 5-1: New USB device found, idVendor=1784, idProduct=0008
[ 627.659051] usb 5-1: New USB device strings: Mfr=1, Product=2, SerialNumber=3
[ 627.659053] usb 5-1: Product: eHome Infrared Transceiver
[ 627.659055] usb 5-1: Manufacturer: Topseed Technology Corp.
[ 627.659057] usb 5-1: SerialNumber: TS0000kJ
[ 627.667054] Registered IR keymap rc-rc6-mce
[ 627.667162] rc rc0: lirc_dev: driver ir-lirc-codec (mceusb) registered at minor = 0
[ 627.667210] input: Media Center Ed. eHome Infrared Remote Transceiver (1784:0008) as /devices/pci0000:00/0000:00:1a.2/usb5/5-1/5-1:1.0/rc/rc0/input7
[ 627.667247] rc0: Media Center Ed. eHome Infrared Remote Transceiver (1784:0008) as /devices/pci0000:00/0000:00:1a.2/usb5/5-1/5-1:1.0/rc/rc0
[ 627.667257] mceusb 5-1:1.0: Registered Topseed Technology Corp. eHome Infrared Transceiver on usb5:3
the red light on the receiver flashes when i press remote control buttons but irw shows nothing. mode2 also shows nothing. i have tried with lircd.conf from lirc website for a rm-vr1 remote (which is what mine is, and i used this when it was working 3 months ago), but still nothing.
i have tried running lircd with both /dev/lirc0 and /dev/lirc/0 (both exist) but there is no output or errors (when running in combination with irw).
any idea what to try next?
