Recently installed centos-minimal(7.4.1708)

After installation to check the networks i used:

nmcli d

DEVICE TYPE STATE CONNECTION

ens33 ethernet unavailable -----

lo loopback unmanaged -----

I used

nmtui

to edit ens33 and

set Ipv4 and ipv6 to automatic

and selected automatically connect option as well

systemctl restart network

showed this:

job for network.service failed because the control process exited with error code look systemctl status network.service and journalctl -xe

o/p of systemctl status network.service

network.service-LSB bring up/down networking
Loaded: (/etc/rc.d/init.d/network; bad; vendor preset :disabled)

Active:failed (result: exitcode)

Process:Execstart=/etc/rc.d/init.d/network start (code=exited,status 1/failure)

localhost.localdomain systemd[1] :Failed to start LSB bring up/down networking

contents of my

/etc../ifcfg-ens33

looked ok to me

type=ethernet

bootproto=dhcp

onboot=yes

ipv4-failure-fatal=no

ipv6-failure-fatal=no

ipv6-init=yes

ipv6-autoconf=yes

Iam a newbie please help me out i tried everything what i found couldnt figure it out

Does minimal install include network manager?

This is a dupe of this: https://www.linuxquestions.org/quest...et-4175636006/

I have reported it to be closed/deleted.

1 members found this post helpful.

Please post your thread in only one forum. Posting a single thread in the most relevant forum will make it easier for members to help you and will keep the discussion in one place. This thread is being closed because it is a duplicate.

1 members found this post helpful.