I am trying to set my gigabit NIC to 1000 MB setting using ethtool. The only way I can get it to register that way is to turn off auto negotiation and that just kills my signal.
Below is the output of the current settings and the commands I have attempted with zero success.
Any thoughts/direction would be appreciated.
Quote:
Tux-Box Desktop # ethtool eth0
Settings for eth0:
Supported ports: [ TP ]
Supported link modes: 10baseT/Half 10baseT/Full
ethtool -s eth0 advertise 0x1000 duplex full autoneg on
100baseT/Half 100baseT/Full
1000baseT/Half 1000baseT/Full
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Half 1000baseT/Full
Advertised pause frame use: No
Advertised auto-negotiation: Yes
Link partner advertised link modes: Not reported
Link partner advertised pause frame use: No
Link partner advertised auto-negotiation: No
Speed: 100Mb/s
Duplex: Full
Port: Twisted Pair
PHYAD: 0
Transceiver: internal
Auto-negotiation: on
MDI-X: Unknown
Supports Wake-on: pg
Wake-on: d
Current message level: 0x000000ff (255)
|
Code:
ethtool -s eth0 advertise 0x1000 duplex full autoneg on
Code:
ethtool -s eth0 advertise 0x020 duplex full autoneg on
Code:
ethtool -s eth0 speed 1000 duplex full autoneg on
Nic -> 1000 MB ?
