RHEL WS Ver. 3, Set ttyS# baud rate.
I have been searching around for the answer to this for quite a few hours and never really seem to get the results I need.
I have been able to send data across the ttyS0 & ttyS1 from the Linux station to my laptop (XP Pro) in Hyper-Term by ls -l > /dev/ttyS0 (or S1) and it works fine at 9600-8-N-1. Then as root I try: setserial /dev/ttyS0 uart 16550A port 0x03f8 irq 4 baud_rate 19200, but when I set Hyper-Term to 19200-8-N-1, I get nothing performing ls -l > /dev/ttyS0. I reboot and then perform setserial -G /dev/ttyS0 to verify my baud rate and I see that the baud_base value has gone back to 115200. I have also tried stty 19200 > /dev/ttyS0 and get the same results.
I am sure it must be a simple flag or option I am missing. Any help you can offer will be greatly appreciated.
|
