Quote:
Originally posted by DrOzz
i think thats something to do with a generic serial port, and if its not in your modules.conf, did you try looking
in /etc/rc.d/rc.modules ?
|
No serial port built-in or modules - nothing in /etc/rc.d/rc.modules.
Quote:
or i think by adding :
char-major-4 off
to your modules.conf file should stop it also ..
|
When I added it without the word alias...
Code:
mingdao@paul:Sat Jan 31 11:29:02~$ cat /etc/modules.conf
alias char-major-195 nvidia
char-major-4 off
mingdao@paul:Sat Jan 31 11:29:15~$
Code:
mingdao@paul:Sat Jan 31 11:21:39~$ startx
XFree86 Version 4.3.0
Release Date: 27 February 2003
X Protocol Version 11, Revision 0, Release 6.6
Build Operating System: Linux 2.4.22 i686 [ELF]
Build Date: 16 September 2003
Before reporting problems, check http://www.XFree86.Org/
to make sure that you have the latest version.
Module Loader present
Markers: (--) probed, (**) from config file, (==) default setting,
(++) from command line, (!!) notice, (II) informational,
(WW) warning, (EE) error, (NI) not implemented, (??) unknown.
(==) Log file: "/var/log/XFree86.0.log", Time: Sat Jan 31 11:21:40 2004
(==) Using config file: "/etc/X11/XF86Config"
NV: could not open control device /dev/nvidiactl (No such device)
(EE) NVIDIA(0): Failed to initialize the NVIDIA kernel module!
(EE) NVIDIA(0): *** Aborting ***
(EE) Screen(s) found, but none have a usable configuration.
Fatal server error:
no screens found
When reporting a problem related to a server crash, please send
the full server output, not just the last messages.
This can be found in the log file "/var/log/XFree86.0.log".
Please report problems to xfree86@xfree86.org.
XIO: fatal IO error 104 (Connection reset by peer) on X server ":0.0"
after 0 requests (0 known processed) with 0 events remaining.
X wouldn't start. You need to have the word alias in the line ->
alias char-major-4 off
which did stop that message.
It still boots just as slow. When booting, it gets to this point in 15 seconds
Code:
PCI: Sharing IRQ 11 with 00:1d.7
tg3: eth0: Link is up at 100 Mbps, full duplex.
tg3: eth0: Flow control is on for TX and on for RX.
and spends about 16 seconds there bringing up the NIC. Then
it finishes the rest in another 15 seconds, still taking 53 secs. to boot.