mandrake 10.2 for ppc
 

I have Mandrake Linux 10.2 for ppc installed on an ibook g3 and i installed it with kde gui, when i boot the machine it loads display manager properly but doesnt boot to a gui, i can login the prompt and use startx to load kde and it loads correctly, does anyone know how i can get it to boot to kde without going to the command prompt. Also after install before restart it displayed a msg say that i might need to enter "setenv boot-device /pci@F2000000/mac-io@17/ata-4@1f000/disk@0:5,\\:tbxi" in the pram but i cannot do this because the "\" key doesnt work on the ibook. Any help would be greatly appreciated.

check your runlevel in /etc/inittab


# Default runlevel. The runlevels used by Mandrakelinux are:
# 0 - halt (Do NOT set initdefault to this)
# 1 - Single user mode
# 2 - Multiuser, without NFS (The same as 3, if you do not have networking)
# 3 - Full multiuser mode
# 4 - unused
# 5 - X11
# 6 - reboot (Do NOT set initdefault to this)
#
id:5:initdefault:

Don't know what to tell you about your backlash situation, other then you may try to remap another key for it...

KC

it is set to 5

X11 seems to be loading fine but still not directly to kde

Hmm, perhaps the problem is in your Xsession* script but I don't even know if the ppc configuration is even the same.

Usually if it is set to 5 and still won't load is suspected a video card problem, however, you say you can starx normaly, so you'll have to go deeper...

If I get anything more I'll post...

KC

thx alot man

is there a way i can get it to boot to a different gui like ice?

guess not?